Saltwater Boat Lifts

Boat Hoist USA Galvanized 6K & 8K - 4 Post Boat Lifts

Boat Hoist USA Galvanized 4 Post Boat Lifts are strong, reliable boat lifts that will last a lifetime, with a very reasonable cost.

Hot dipped galvanized top beams have been used in the boat lift industry for over 50 years; they are stronger than aluminum and will last forever in the marine environment.

This type of galvanized boat lift will hold 6,000 - 8,000 pounds compounded. The lift comes standard with two top beams, cradle beams, galvanized cable, pipe, chock angles for two bunks, two flat plate hoists with hoist covers and standard wiring at 110 volt. Lifts do not include wood bunk boards or pilings.

Added Extras to enhance your lift: guide posts, guide post bumpers, aluminum cable winders or the GR2 Gem Remote that will operate two motors at one time.

	Electrical Requirements: 6K = Two 3/4 hp motors at 22 amps minimum, #10 wire* 8K = Two 1 hp motors at 26 amps minimum, #8 wire *       * Wire size depends on length of wire from main power to lift.
8” pilings need to be installed with sufficient seabed penetration to support the weight of the boat. Pilings must be square and level to each other. The two drive end pilings (the pilings where the hoists are mounted) should be 6” shorter than the 2 other pilings. ANY movement of the pilings after installation will adversely affect lift operation and safety.